Thrill Machining
  ashland technologies quality machined and fabricated parts at a lower cost quality machined and fabricated parts produced by ashland technologies
  quality machined and fabricated parts produced by ashland technologies
lower cost, least pain for machined and fabricated parts
  lower cost, least pain for machined and fabricated parts  
could you be paying less for machined and fabricated parts? find out in just 48hours













Position: 1st or 2nd Shift CNC Set up Operator/Programmer - Apply Here
Scope Of Responsibilities:
    Ash-Tec, a leading contract manufacturer of machined and fabricated parts, is seeking a highly motivated individual with a strong work ethic to fill the position of CNC Set up Operator/Programmer.
Job Qualifications
    Ability to communicate orally and in writing (basic oral instructions, technically written memos and instructions.)

    Ability to read and interpret blue prints and other drawings, follow routers, use math to perform calculations, and use hand held and other measuring tools.

    Ability to effective and efficiently program and operate manufacturing equipment, both manual and CNC including lathe machines, milling machines, sawing equipment, hand tools, etc.

    High school diploma required. Graduation from a technical school or college, preferred

    Minimum 5 years CNC experience.

    Experience with Haas CNC equipment preferred
Daily Responsibilities:
    1.Take information from "Print to Part" on CNC machining jobs that are new to the shop. This includes G&M code programming at the machine; fixture design and building; tool selection, loading, setting, and program adjustments; first piece inspection; and required inspection procedures.

    2.Set-up of repeat jobs on CNC machining centers for other operators. Tear down of previous job; load fixtures; load and preset tooling; recall current program; make program adjustments; and first piece inspection.
    3.Troubleshoot other operator’s machines when they run into difficulty.

    4.Run first run and production including load/unload; check parts to size; deburr parts; reject parts that do not conform to dimensional or visual requirement.

    5.Maintain work area and equipment in a clean orderly condition and follow prescribed safety procedures.

    6.Other duties as assigned.
Special Requirements:
    Some moderate lifting required.
    Some push/pulling of objects.
    Standing.
    Repetitive tasks.
    Willingness to work overtime, when necessary
Apply for this poition

Machinist Positions | Administrative Positions | Benefits Package



Design by Fuzzy Bean